LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (UF1AE Transfer Case) >> Transfer Valve Body Assembly >> Installation

Transfer Valve Body Assembly: Installation

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL TRANSFER CONTROL SOLENOID  (See REASSEMBLY  )
  2. INSTALL TRANSFER VALVE BODY ASSEMBLY 
    1. Connect the transfer wire connector to the transfer control solenoid.
    2. Install the transfer upper valve body with the 4 bolts.

      Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf) 

      Fig 1: Installing Transfer Valve Body Assembly
      G05295959Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL TRANSFER OIL PAN  (See INSTALLATION  )
  4. INSTALL TRANSFER DYNAMIC DAMPER  (See INSTALLATION  )
  5. INSTALL ENGINE REAR MOUNTING MEMBER  (See INSTALLATION  )
  6. INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR  (See INSTALLATION )
  7. INSTALL FRONT EXHAUST PIPE ASSEMBLY  (See INSTALLATION )
  8. INSTALL HEATED OXYGEN SENSOR  (See INSTALLATION )
  9. INSTALL FRONT CENTER FLOOR BRACE  (See INSTALLATION )
  10. INSTALL REAR NO. 1 FLOOR PANEL BRACE  (See INSTALLATION )
  11. ADD AUTOMATIC TRANSMISSION FLUID  (See ADJUSTMENT )
  12. CHECK FOR EXHAUST GAS LEAKS 
scientia non olet · About LEMON Manuals