Transfer Control Solenoid: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL TRANSFER CONTROL SOLENOID
1. Install the transfer control solenoid and solenoid lock plate to the transfer upper valve body with the bolt.
  Torque: 6.4 N*m (65 kgf*cm, 57 in.*lbf)
  
  HINT:
  
  Install the solenoid lock plate into the cutout on the transfer control solenoid.
  
  Fig 1: Installing Transfer Control Solenoid
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL TRANSFER VALVE BODY ASSEMBLY (See REMOVAL )
INSTALL TRANSFER OIL PAN (See INSTALLATION )
INSTALL TRANSFER DYNAMIC DAMPER (See INSTALLATION )
INSTALL ENGINE REAR MOUNTING MEMBER (See INSTALLATION )
INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR (See INSTALLATION )
INSTALL FRONT EXHAUST PIPE ASSEMBLY (See INSTALLATION )
INSTALL HEATED OXYGEN SENSOR (See INSTALLATION )
INSTALL FRONT CENTER FLOOR BRACE (See INSTALLATION )
INSTALL REAR NO. 1 FLOOR PANEL BRACE (See INSTALLATION )
ADD AUTOMATIC TRANSMISSION FLUID (See ADJUSTMENT )
CHECK FOR EXHAUST GAS LEAKS