Section 7 ((Door / Hatch)): Hood: Reassembly

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

CONNECT WASHER HOSE ASSEMBLY
1. Engage the 4 clamps and connect the washer hose assembly
Fig 1: Identifying Washer Hose Assembly And Clamps
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
ADJUST WASHER NOZZLE SUB-ASSEMBLY (See ADJUSTMENT )
INSTALL WASHER NOZZLE SUB-ASSEMBLY (See INSTALLATION )
INSTALL HOOD INSULATOR
1. Install the hood insulator with the 12 clips
  
  Fig 2: Identifying Hood Insulator And Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL HOOD TO RADIATOR SUPPORT SEAL
1. Install the hood to radiator support seal with the 8 clips
  
  Fig 3: Identifying Radiator Support Seal And Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL HOOD AUXILIARY HOOK CATCH
1. Install the hood auxiliary hook catch with the 2 bolts.
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
Fig 4: Identifying Hood Auxiliary Hook Catch And Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSPECT WASHER NOZZLE SUB-ASSEMBLY (See ON-VEHICLE INSPECTION )