LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Seat Belt) >> Rear Seat Outer Belt Assembly With PRETENSIONER >> Removal

Rear Seat Outer Belt Assembly With PRETENSIONER: Removal

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system (See PRECAUTION ).
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  2. REMOVE REAR SEAT HEADREST ASSEMBLY LH 
  3. REMOVE REAR SEAT HEADREST ASSEMBLY RH 
  4. REMOVE REAR SEAT CUSHION ASSEMBLY  (See REMOVAL )
  5. REMOVE REAR SEATBACK ASSEMBLY  (See REMOVAL )
  6. REMOVE REAR DOOR SCUFF PLATE LH  (See REMOVAL )
  7. REMOVE REAR DOOR SCUFF PLATE RH  (See REMOVAL )
  8. REMOVE REAR SEAT SIDE GARNISH LH  (See REMOVAL )
  9. REMOVE REAR SEAT SIDE GARNISH RH  (See REMOVAL )
  10. REMOVE ROOF SIDE INNER GARNISH LH  (See REMOVAL )
  11. REMOVE ROOF SIDE INNER GARNISH RH  (See REMOVAL )
  12. REMOVE CENTER STOP LIGHT SET  (See REMOVAL )
  13. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY 
    1. Remove the bolt and disconnect the floor end of the rear seat 3 point type belt assembly LH.

      HINT:

      Use the same procedures for the RH side and the LH side.

      Fig 1: Identifying Floor End Bolt Of Rear Seat 3 Point Type Belt Assembly LH
      G05320196Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using a molding remover, disengage the 4 claws and remove the rear seat shoulder belt cover LH

      HINT

      Use the same procedures for the RH side and LH side.

      Fig 2: Disengaging Claws Of Rear Seat Shoulder Belt Cover LH
      G05320203Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Disengage the 3 clips.
    4. Pass the 2 rear seat belt floor anchors through the package tray trim panel assembly.
    5. Disengage the 5 claws and remove the package tray trim panel assembly.
      Fig 3: Identifying Package Tray Trim Panel Assembly Claws
      G05755162Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  14. REMOVE REAR SEAT 3 POINT TYPE BELT ASSEMBLY 
    1. Using a screwdriver, pull out the locking button in the direction shown by the arrow to release the lock, and disconnect the pretensioner connector as shown in the illustration.
      Fig 4: Disconnecting Pretensioner Connector
      G05320222Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 bolts and the rear seat 3 point type belt assembly.
      Fig 5: Identifying Rear Seat 3 Point Type Belt Assembly Bolts
      G05320223Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals