Tire Pressure Warning Ecu: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL TIRE PRESSURE WARNING RECEIVER ASSEMBLY
1. Install the tire pressure warning receiver assembly.
  
  Fig 1: Identifying Tire Pressure Warning Receiver Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the bolt
  Torque: 3.5 N*m (36 kgf*cm, 31 in.*lbf)
INSTALL INTEGRATION CONTROL PANEL WITH RADIO RECEIVER ASSEMBLY (w/o Navigation System) (See INSTALLATION )
INSTALL MULTI-DISPLAY WITH RADIO RECEIVER ASSEMBLY (w/ Navigation System) (See INSTALLATION )
INSTALL CENTER LOWER INSTRUMENT CLUSTER FINISH PANEL (See INSTALLATION )
INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY (See INSTALLATION )
INSTALL FRONT ASH RECEPTACLE ASSEMBLY (See INSTALLATION )
INSTALL CONSOLE PANEL SUB-ASSEMBLY (See INSTALLATION )
INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH (See INSTALLATION )
INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH (See INSTALLATION )
INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
REGISTER OF TRANSMITTER ID
See REGISTRATION .
INSPECT TIRE PRESSURE WARNING SYSTEM
See TEST MODE PROCEDURE