Tire Pressure Warning Antenna: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FRONT TIRE PRESSURE ANTENNA RH
1. Connect the connector.
  
  Fig 1: Locating Front Tire Pressure Antenna RH Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the front tire pressure antenna RH with the nut.
  Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf)
  
  HINT:
  
  Engage the tab into the hole as shown in the illustration to install the front tire pressure antenna RH.
INSTALL FRONT FENDER LINER RH
INSTALL ENGINE UNDER COVER
INSTALL FRONT WHEEL RH
Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf)
INSTALL REAR TIRE PRESSURE ANTENNA LH
1. Install the rear tire pressure antenna LH with the 2 nuts.
  Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf)
  
  Fig 3: Identifying Rear Tire Pressure Antenna LH Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the grommet
  
  Fig 4: Locating Grommet
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the connector.
Fig 5: Locating Rear Tire Pressure Antenna LH Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR FENDER LINER LH
INSTALL NO. 2 REAR FLOOR HOUSING SHIELD (See INSTALLATION )
INSTALL REAR WHEEL LH
Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf)
INSTALL REAR SEATBACK ASSEMBLY (See INSTALLATION )
INSTALL REAR SEAT HEADREST ASSEMBLY RH
INSTALL REAR SEAT HEADREST ASSEMBLY LH
INSTALL REAR SEAT CUSHION ASSEMBLY (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
INSPECT TIRE PRESSURE WARNING SYSTEM
See TEST MODE PROCEDURE