Rocker Panel Molding: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL ROCKER PANEL MOLDING ASSEMBLY
1. Engage the 16 clips and install the rocker panel molding assembly
  
  Fig 1: Identifying Rocker Panel Molding Assembly Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the 2 screws
  
  Fig 2: Identifying Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the 4 screws and clip.
  
  Fig 3: Identifying Screws And Clip
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Install the 7 clips
  
  Fig 4: Identifying Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 2 FRONT DOOR WEATHERSTRIP
1. Engage the 13 clips and install the No. 2 front door weatherstrip
  
  Fig 5: Identifying No. 2 Front Door Weatherstrip Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 2 REAR FLOOR HOUSING SHIELD
1. Install the clip and No. 2 rear floor housing shield
2. Install the screw.
  
  Fig 6: Identifying No. 2 Rear Floor Housing Shield Screw And Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002