Inspection Procedure

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

CHECK SIDE AIRBAG SENSOR RH

Turn the engine switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Interchange the side airbag sensor LH with RH and connect the connectors
Connect the cable to the negative (-) battery terminal
Turn the engine switch on (IG), and wait for at least 60 seconds.
Clear the DTCs stored in the memory (See DTC CHECK / CLEAR ).
Turn the engine switch off
Turn the engine switch on (IG), and wait for at least 60 seconds

Check for DTCs (See DTC CHECK / CLEAR )

Fig 1: Identifying DLC3 Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Result

RESULT CHART

Result	Proceed to
DTC B1620/21 and B1625/22 are not output	A
DTC B1625/22 is output	B
DTC B1620/21 is output	C

HINT

Codes other than DTC B1620/21 and B1625/22 may be output at this time, but they are not related to this check

B: REPLACE CENTER AIRBAG SENSOR ASSEMBLY (See REMOVAL )

C: REPLACE SIDE AIRBAG SENSOR RH (See REMOVAL )

A: USE SIMULATION METHOD TO CHECK (See DIAGNOSIS SYSTEM )