LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Heating / Air Conditioning System) >> Front Blower Motor >> Removal

Front Blower Motor: Removal

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE FRONT DOOR SCUFF PLATE RH 

    HINT.

    Use the same procedure for the RH side and LH side (See REMOVAL )

  2. REMOVE FRONT DOOR OPENING TRIM COVER RH 

    HINT.

    Use the same procedure for the RH side and LH side (See REMOVAL ).

  3. REMOVE SIDE INSTRUMENT PANEL RH  (See REMOVAL )
  4. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY  (See REMOVAL )
  5. REMOVE SKID CONTROL ECU  (See REMOVAL )
  6. REMOVE COOLING UNIT WITH FAN MOTOR SUB-ASSEMBLY 
    1. Disconnect the connector.
    2. Remove the 3 screws and the cooling unit with fan motor sub-assembly.
      Fig 1: Locating Screws And Cooling Unit With Fan Motor Sub-Assembly
      G05755403Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals