LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Automatic Transaxle) >> Air Cooled Oil Cooler >> Installation

Air Cooled Oil Cooler: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL OIL COOLER ASSEMBLY 
    1. Install the oil cooler assembly to the oil cooler bracket with the 3 bolts.

      Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf) 

    2. Connect the 2 oil cooler hoses to the oil cooler assembly.
      3. Fig 1: Locating Oil Cooler Assembly Bolts
      G05750913Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL FRONT BUMPER ASSEMBLY  (See INSTALLATION )
  3. INSTALL RADIATOR GRILLE PROTECTOR  (See INSTALLATION )
  4. INSTALL HIGH PITCHED HORN  (See INSTALLATION )
  5. INSTALL COOL AIR INTAKE DUCT SEAL  (See INSTALLATION )
  6. ADD WASHER FLUID (w/ Headlight Cleaner System)  (See INSTALLATION )
  7. VEHICLE PREPARATION FOR FOG LIGHT AIMING  (See ADJUSTMENT )
  8. PREPARATION FOR FOG LIGHT AIMING  (See ADJUSTMENT )
  9. INSPECT FOG LIGHT AIMING  (See ADJUSTMENT )
  10. ADJUST FOG LIGHT AIMING  (See ADJUSTMENT )
  11. ADD AUTOMATIC TRANSMISSION FLUID 
    1. Add automatic transmission fluid (See AUTOMATIC TRANSMISSION FLUID  ).
  12. INSTALL NO. 2 ENGINE UNDER COVER 
scientia non olet · About LEMON Manuals