LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Wiper & Washer) >> Headlight Cleaner Motor >> Installation

Headlight Cleaner Motor: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY 
    1. Install the headlight cleaner motor and pump assembly
    2. Connect each connector
      Fig 1: Locating Headlight Cleaner Motor And Pump Assembly Connector
      G05756360Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Connect the No 2 headlight cleaner hose to the headlight cleaner motor and pump assembly.
    Fig 2: Connecting No 2 Headlight Cleaner Hose To Headlight Cleaner Motor And Pump Assembly
    G05756363Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL FRONT BUMPER ASSEMBLY  (See INSTALLATION )
  3. ADD WASHER FLUID 
    1. Add washer fluid to the washer jar.
  4. INSTALL RADIATOR GRILLE PROTECTOR  (See INSTALLATION )
  5. INSTALL COOL AIR INTAKE DUCT SEAL  (See INSTALLATION )
  6. VEHICLE PREPARATION FOR FOG LIGHT AIMING ADJUSTMENT  (See ADJUSTMENT )
  7. PREPARATION FOR FOG LIGHT AIMING  (See ADJUSTMENT )
  8. INSPECT FOG LIGHT AIMING  (See ADJUSTMENT )
  9. ADJUST FOG LIGHT AIMING  (See ADJUSTMENT )
scientia non olet · About LEMON Manuals