LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Lighting (Exterior)) >> License Plate Light Assembly >> Installation

License Plate Light Assembly: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL LICENSE PLATE LIGHT ASSEMBLY 
    1. Engage the 2 claws and install the license plate light assembly.
    2. Connect the connector.
    Fig 1: Engaging Claws
    G05756576Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL LUGGAGE COMPARTMENT OUTSIDE DOOR GARNISH SUB-ASSEMBLY  (See INSTALLATION )
  3. INSTALL REAR LIGHT ASSEMBLY LH  (See REASSEMBLY  )
  4. INSTALL REAR LIGHT ASSEMBLY RH 

    HINT:

    Use the same procedure for the RH side and the LH side.

  5. INSTALL TELEVISION CAMERA ASSEMBLY (w/ Parking Assist Monitor System)  (See INSTALLATION )
  6. INSTALL LUGGAGE KEY ELECTRICAL SWITCH  (See INSTALLATION )
  7. INSTALL LUGGAGE COMPARTMENT DOOR REINFORCEMENT  (See INSTALLATION )
  8. INSTALL LUGGAGE COMPARTMENT DOOR COVER  (See INSTALLATION )
  9. INSTALL LUGGAGE COMPARTMENT DOOR INSIDE HANDLE  (See INSTALLATION )
  10. INSTALL LUGGAGE LOCK CONTROL CABLE PLATE  (See INSTALLATION )
  11. INSTALL LUGGAGE COMPARTMENT DOOR ASSIST GRIP  (See INSTALLATION )
scientia non olet · About LEMON Manuals