LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Lighting (Exterior)) >> Headlight Dimmer Switch >> Installation

Headlight Dimmer Switch: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL HEADLIGHT DIMMER SWITCH ASSEMBLY 
    1. Install the headlight dimmer switch assembly as shown in the illustration.
      Fig 1: Installing Headlight Dimmer Switch
      G05252505Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the headlight dimmer switch assembly with the claw and the clamp
    3. Connect the connector
    4. Fig 2: Identifying Headlight Dimmer Switch Assembly With Claw And Clamp
      G05756586Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL TILT AND TELESCOPIC SWITCH  (See INSTALLATION )
  3. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY  (See INSTALLATION )
  4. INSTALL SPIRAL CABLE WITH STEERING ANGLE SENSOR  (See INSTALLATION )
  5. INSTALL STEERING COLUMN COVER  (See INSTALLATION )
  6. ADJUST SPIRAL CABLE  (See INSTALLATION )
  7. INSTALL STEERING WHEEL ASSEMBLY  (See INSTALLATION )
  8. INSPECT STEERING WHEEL CENTER POINT 
  9. INSTALL STEERING PAD  (See INSTALLATION )
  10. INSTALL LOWER NO. 2 STEERING WHEEL COVER  (See INSTALLATION )
  11. INSTALL LOWER NO. 3 STEERING WHEEL COVER  (See INSTALLATION )
  12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE: Some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  13. INSPECT STEERING PAD  (See INSTALLATION )
  14. INSPECT SRS WARNING LIGHT 
    1. Inspect the SRS warning light (See DIAGNOSIS SYSTEM ).