LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Steering Column) >> Tilt And Telescopic Manual Switch >> Installation

Tilt And Telescopic Manual Switch: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL TILT AND TELESCOPIC SWITCH 
    1. Engage the claw to install the tilt and telescopic switch
    2. Connect the connector.
      Fig 1: Locating Tilt And Telescopic Switch Connector
      G05753074Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL LOWER STEERING COLUMN COVER 
    1. Engage the 2 claws to install the lower steering column cover.
      NOTE: Do not damage the tilt and telescopic switch.
    2. Install the 3 screws.

      Torque: 2.0 N*m (20 kgf*cm, 18 in.*lbf) 

  3. ADJUST SPIRAL CABLE  (See INSTALLATION )
  4. INSTALL STEERING WHEEL ASSEMBLY  (See INSTALLATION  )
    Fig 2: Identifying Lower Steering Column Cover Screws
    G05753073Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. INSPECT STEERING WHEEL CENTER POINT 
  6. INSTALL STEERING PAD  (See INSTALLATION )
  7. INSTALL LOWER NO. 3 STEERING WHEEL COVER  (See INSTALLATION )
  8. INSTALL LOWER NO. 2 STEERING WHEEL COVER  (See INSTALLATION )
  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL  (See INSTALLATION  )
  10. INSPECT STEERING PAD  (See INSTALLATION )
  11. INSPECT SRS WARNING LIGHT 

    See DIAGNOSIS SYSTEM

scientia non olet · About LEMON Manuals