Rear Axle Hub Bolt: Replacement

HINT

• Use the same procedure for the RH side and LH side
• The procedure listed below is for the LH side

1. REMOVE REAR WHEEL 
2. SEPARATE REAR DISC BRAKE CYLINDER ASSEMBLY  (See DISASSEMBLY )
3. REMOVE REAR DISC  (See REMOVAL )
4. REMOVE REAR AXLE HUB BOLT 
   1. Temporarily install 2 nuts and 2 washers to the rear axle hub bolt as shown in the illustration

      HINT

      Install hub nuts to prevent damage to the hub bolts.

   2. Using SST and a screwdriver or an equivalent tool to hold the rear axle hub and bearing assembly, remove the rear axle hub bolt

      SST 09628-10011 

      NOTE: Do not damage the threads of the rear axle hub bolts.
      Fig 1: Holding Rear Axle Hub Removing Nuts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. INSTALL REAR AXLE HUB BOLT 
   1. Install a washer and nut to a new rear axle hub bolt as shown in the illustration
   2. Using a screwdriver or an equivalent tool to hold the rear axle hub and bearing assembly, install the rear axle hub bolt by tightening the nut
      NOTE: Do not damage the threads of the rear axle hub bolt.

      HINT.

      Install hub nuts to prevent damage to the hub bolts

      Fig 2: Holding Rear Axle Hub Tightening Nuts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. INSTALL REAR DISC  (See INSTALLATION )
7. INSTALL REAR DISC BRAKE CYLINDER ASSEMBLY  (See REASSEMBLY )
8. ADJUST PARKING BRAKE SHOE CLEARANCE AND PARKING BRAKE PEDAL TRAVEL  (See ADJUSTMENT )
9. INSTALL REAR WHEEL 

   Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf)