Parking Brake Assembly: Disassembly

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

HINT

When removing the parking brake anchor block sub-assembly, refer to the instructions for Removal of the rear axle hub and bearing assembly (See REMOVAL ).

REMOVE REAR WHEEL
SEPARATE REAR DISC BRAKE CYLINDER ASSEMBLY
1. Remove the 2 bolts and separate the rear disc brake cylinder assembly
NOTE: Hang the caliper with wire or equivalent.

Fig 1: Locating Rear Disc Brake Cylinder Assembly Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE REAR DISC (See REMOVAL )
REMOVE NO. 2 PARKING BRAKE SHOE RETURN TENSION SPRING
1. Using SST, remove the No. 2 parking brake shoe return tension spring.
  SST 09703-30011
  
  Fig 2: Removing No. 2 Parking Brake Shoe Return Tension Spring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE NO. 1 PARKING BRAKE SHOE RETURN TENSION SPRING
1. Using SST, remove the No. 1 parking brake shoe return tension spring
  SST 09703-30011
  
  Fig 3: Removing No. 1 Parking Brake Shoe Return Tension Spring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE PARKING BRAKE SHOE ADJUSTING SCREW SET
1. Spread apart the No. 1 parking brake shoe assembly and No. 2 parking brake shoe assembly, and remove the parking brake shoe adjusting screw set.
  
  Fig 4: Removing Parking Brake Shoe Adjusting Screw Set
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY
1. Using SST, remove the No. 1 shoe hold down spring cup, No. 1 compression spring and No. 1 shoe hold down spring pin
  SST 09718-00011
2. Remove the No. 1 parking brake shoe assembly
  HINT
  
  Use the service hole to retain the No. 1 shoe hold down spring pin.
  
  Fig 5: Removing No. 1 Parking Brake Shoe Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE NO. 2 PARKING BRAKE SHOE ASSEMBLY
1. Using SST, remove the No. 1 shoe hold down spring cup, No. 1 compression spring and No. 1 shoe hold down spring pin
  SST 09718-00011
2. Remove the No. 2 parking brake shoe assembly
  HINT:
  
  Use the service hole to retain the No. 1 shoe hold down spring pin with your finger
  
  Fig 6: Removing No. 2 Parking Brake Shoe Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE PARKING BRAKE SHOE LEVER SUB-ASSEMBLY
1. Remove the parking brake shoe lever sub-assembly
Fig 7: Removing Parking Brake Shoe Lever Sub-Assembly
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002