Starting (4GR-FSE): Starter: Installation

INSTALL STARTER ASSEMBLY
1. Install the starter with the 2 bolts.
  Torque: 58 N*m (591 kgf*cm, 43 ft.*lbf)
2. Connect the wire harness to terminal 30 and install the nut, and then attach the terminal cap.
  Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf)
3. Connect the terminal 50 connector to the starter assembly.
  
  Fig 1: Locating Starter With Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY LH
1. Install a new gasket and the exhaust manifold with 6 new nuts.
  Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf)
  
  Fig 2: Locating Exhaust Manifold With Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the air fuel ratio sensor (for sensor 1) connector.
  
  Fig 3: Locating Air Fuel Ratio Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the engine room No. 3 relay block with the bolt and nut.
  Torque: 12.5 N*m (127 kgf*cm, 9 ft.*lbf)
  
  Fig 4: Locating Engine Room No. 3 Relay Block Nut And Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Install the engine wire bracket with the bolt (A).
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
5. Install the ground cable with the 2 bolts (B, C).
  Torque:
  
  Bolt (B)
  
  10 N*m (102 kgf*cm, 7 ft.*lbf)
  
  Bolt (C)
  
  13 N*m (133 kgf*cm, 10 ft.*lbf)
  
  Fig 5: Locating Ground Cable With Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY (for Automatic Transmission) (See INSTALLATION )
INSTALL FRONT PROPELLER SHAFT ASSEMBLY (for 4WD) (See INSTALLATION )
INSTALL FRONT EXHAUST PIPE ASSEMBLY (See INSTALLATION )
INSTALL HEATED OXYGEN SENSOR (for 2WD) (See INSTALLATION )
INSTALL HEATED OXYGEN SENSOR (for 4WD) (See INSTALLATION )
INSTALL FRONT CENTER FLOOR BRACE (See INSTALLATION )
INSTALL REAR NO. 1 FLOOR PANEL BRACE (See INSTALLATION )
INSTALL ENGINE ROOM SIDE COVER LH (See INSTALLATION )
INSTALL COOL AIR INTAKE DUCT SEAL (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (See INSTALLATION )
CHECK FOR EXHAUST LEAKS
PERFORM INITIALIZATION
1. Perform initialization procedure (See PRECAUTION ).
  HINT:
  
  Some vehicle systems require initialization after reconnecting the negative battery cable.