AIR HOSE (for Ottoman): Installation

HINT:

A bolt without a torque specification is shown in the standard bolt chart (see SPECIFIED TORQUE FOR STANDARD BOLTS ).

1. INSTALL AIR HOSE 
   1. Attach the 2 claws and install the air hose.
   2. Install the 2 hose clamps and bolt.
      Fig 1: Locating Air Hose Bolt

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. Install the 2 hose clamps and connect the air hose connector.
      Fig 2: Identifying Air Hose Clamps

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. INSTALL REAR SEAT 3 POINT TYPE BELT ASSEMBLY LH  (See INSTALLATION )
3. INSTALL ROOF SIDE NO. 2 AIR DUCT LH (w/ Rear Cooler)  (See INSTALLATION )
4. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY RH  (See INSTALLATION )
5. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH  (See INSTALLATION )
6. INSTALL REAR FLOOR FINISH PLATE  (See INSTALLATION )
7. INSTALL LUGGAGE COMPARTMENT TRIM COVER SUB-ASSEMBLY FRONT  (See INSTALLATION )
8. INSTALL NO. 1 COOLER COVER (w/ Rear Cooler)  (See INSTALLATION )
9. INSTALL LUGGAGE COMPARTMENT NO. 2 TRIM HOOK (w/o Rear Cooler)  (See INSTALLATION )
10. INSTALL LUGGAGE COMPARTMENT LIGHT ASSEMBLY  (See INSTALLATION )
11. INSTALL DECK TRIM SIDE BOARD LH  (See INSTALLATION )
12. INSTALL DECK TRIM SIDE BOARD RH  (See INSTALLATION )
13. INSTALL ROPE HOOK ASSEMBLY  (See INSTALLATION )
14. INSTALL ROPE HOOK  (See INSTALLATION )
15. INSTALL LUGGAGE COMPARTMENT FLOOR MAT SUB-ASSEMBLY  (See INSTALLATION )
16. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY 
    1. w/ Rear Sunshade:

       Install the package tray trim panel (see INSTALLATION ).

    2. w/o Rear Sunshade:

    Install the package tray trim panel (see INSTALLATION ).

17. INSTALL ROOF SIDE INNER GARNISH RH  (See INSTALLATION )
18. INSTALL ROOF SIDE INNER GARNISH LH  (See INSTALLATION )
19. INSTALL REAR SEAT SIDE GARNISH RH  (See INSTALLATION )
20. INSTALL REAR SEAT SIDE GARNISH LH  (See INSTALLATION )
21. INSTALL REAR DOOR SCUFF PLATE RH 
    1. Use the same procedures described for the LH side.
22. INSTALL REAR DOOR SCUFF PLATE LH  (See INSTALLATION )
23. INSTALL REAR SEATBACK ASSEMBLY RH (See  INSTALLATION  ) 
24. INSTALL REAR SEAT CONSOLE BOX ASSEMBLY  (See INSTALLATION )
25. INSTALL REAR SEATBACK ASSEMBLY LH (See  INSTALLATION  ) 
26. INSTALL REAR SEAT CUSHION ASSEMBLY RH (See  INSTALLATION  ) 
27. INSTALL REAR SEAT CUSHION ASSEMBLY LH (See  INSTALLATION  ) 
28. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
29. INSTALL COWL TOP VENTILATOR LOUVER RH  (See INSTALLATION )
30. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION ).
       NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
31. CHECK SRS WARNING LIGHT 
    1. Check the SRS warning light (see DIAGNOSIS SYSTEM ).