Rear Package Tray Speaker: Removal
- REMOVE COWL TOP VENTILATOR LOUVER RH (See REMOVAL )
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.NOTE: After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
- REMOVE REAR DOOR SCUFF PLATE LH
- REMOVE REAR DOOR SCUFF PLATE RH
- REMOVE REAR SEAT ASSEMBLY
- REMOVE REAR SEAT SIDE GARNISH LH (See REMOVAL )
- REMOVE REAR SEAT SIDE GARNISH RH (See REMOVAL )
- REMOVE ROOF SIDE GARNISH INNER LH (See REMOVAL )
- REMOVE ROOF SIDE GARNISH INNER RH (See POWER SOURCE CIRCUIT )
- REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (See REMOVAL )
- REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Sunshade) (See REMOVAL )
- REMOVE STEREO COMPONENT SPEAKER ASSEMBLY
- Disconnect the speaker connector.
- Remove the 4 bolts and speaker.NOTE: Do not touch the cone part of the speaker.