LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2007 >> GS 450h >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper & Washer >> Wiper Switch >> Removal

Wiper Switch: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD 
  3. REMOVE NO. 3 STEERING WHEEL COVER LOWER  (See REMOVAL )
  4. REMOVE NO. 2 STEERING WHEEL COVER LOWER  (See REMOVAL )
  5. REMOVE STEERING PAD  (See REMOVAL )
  6. REMOVE STEERING WHEEL ASSEMBLY  (See REMOVAL )
  7. REMOVE STEERING COLUMN COVER  (See REMOVAL )
  8. REMOVE SPIRAL CABLE WITH STEERING SENSOR  (See REMOVAL )
  9. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY 
    1. Disconnect the connector.
    2. Detach the claw and remove the wiper switch.
      NOTE: If the claw is pushed with excessive force, it may break.
      Fig 1: Identifying Claw On Wiper Switch
      G05310882Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals