Fuel Pressure Pulsation Damper: Installation
- INSTALL FUEL PRESSURE PULSATION DAMPER
- Temporarily install 2 new gaskets, the fuel tube and the fuel pressure pulsation damper to the fuel pump.
- Using SST, tighten the fuel pressure pulsation damper.
SST 09612-24014 (09617-24011)
Torque: without SST
40 N*m (408 kgf*cm, 30 ft.*lbf) with SST
35 N*m (357 kgf*cm, 26 ft.*lbf)
HINT:
- Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
- Make sure SST and wrench are connected in a straight line.
- INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE (See INSTALLATION )
- CONNECT NO. 2 VENTILATION HOSE (See INSTALLATION )
- INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY (See INSTALLATION )
- INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH (See INSTALLATION )
- INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH (See INSTALLATION )
- INSTALL FRONT FENDER TO COWL SIDE SEAL LH (See INSTALLATION )
- INSTALL FRONT FENDER TO COWL SIDE SEAL RH (See INSTALLATION )
- INSTALL FRONT PILLAR TO FRONT SIDE SEAL SUB-ASSEMBLY LH (See INSTALLATION )
- INSTALL FRONT PILLAR TO FRONT SIDE SEAL SUB-ASSEMBLY RH (See INSTALLATION )
- INSTALL V-BANK COVER SUB-ASSEMBLY (See INSTALLATION )
- INSTALL ENGINE ROOM SIDE COVER RH (See INSTALLATION )
- INSTALL ENGINE ROOM SIDE COVER LH (See INSTALLATION )
- INSTALL COOL AIR INTAKE DUCT SEAL (See INSTALLATION )
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
- PERFORM INITIALIZATION
- Perform initialization (see
INITIALIZATION
).NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable to the negative (-) battery terminal.
- Perform initialization (see
INITIALIZATION
).