LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Roof Opening Panel -- Range Rover Velar/L560) >> Roof Opening Panel >> Removal And Installation >> Roof Opening Panel Guide Rails (G2299454) >> Installation

Roof Opening Panel Guide Rails (G2299454): Installation

WARNING: This page is about a different car, the 2019 Land Rover Range Rover Velar. However, it is still accessible from the selected car via links, so may be relevant.
  1. CAUTION:
    • Make sure to protect surrounding trim components from roof blind motor cable debris. Failure to follow this instruction could cause damage to the vehicle.
    • Gloves must be worn when handling the roof blind motor cables.
    • Make sure the roof panel motor cables are installed.
    • Carefully install the roof opening panel guide rail to the correct position.
    • Install and tighten the 9 roof opening panel guide rail bolts.

      Torque  : 3.5 Nm 

  2. Push both of the roof opening panel guide rails all the way backwards to the 'open' position.
  3. Install the roof opening panel motor.

    Refer to: ROOF OPENING PANEL MOTOR 

  4. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

  5. Install the roof opening panel air deflector.

    Refer to: ROOF OPENING PANEL AIR DEFLECTOR 

  6. Install the roof opening panel.

    Refer to: ROOF OPENING PANEL GLASS 

  7. Initialize the roof opening panel.

    Refer to: MOTOR SYNCHRONIZATION 

scientia non olet · About LEMON Manuals