LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Roof Opening Panel -- Range Rover Velar/L560) >> Roof Opening Panel >> General Procedures >> Motor Synchronization (G1866216)

Motor Synchronization (G1866216)

WARNING: This page is about a different car, the 2019 Land Rover Range Rover Velar. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: The Anti-trap system is disabled during the reset cycle. Make sure that no occupants have any part of their body in a position where it could be trapped.
  1. WARNING: Make sure that the component is at ambient air temperature.
    CAUTION:
    • Make sure that the Transmission Control Switch (TCS) is in Park (P) position.
    • Make sure that the selector lever is in Neutral (N) position.
    • Set the ignition to the ON position.
    • Operate the switch, fully close the roof opening panel and the roof panel blind(s). Release the switches.
  2. NOTE: If the roof opening panel does not operate after 60 seconds. Connect the Jaguar approved diagnostic tool, clear the Diagnostic Trouble Codes (DTCs).
    • Fully press and hold the front of the roof opening panel switch for more than 10 seconds, to start the reset cycle. Continue to hold the front of the roof opening panel switch.
    • The reset cycle will fully open the roof blind(s).
    • Fully open and then fully close the roof opening panel.
    • Fully close the roof blind(s).
    • Once the open/close cycle has completed and the roof panel blind(s) has stopped moving, release the switch.
    • The roof opening panel is now synchronized.
    • The roof opening panel can now be operated as normal.
scientia non olet · About LEMON Manuals