LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Roof Opening Panel -- Range Rover Velar/L560) >> Roof Opening Panel >> Removal And Installation >> Roof Opening Panel Blind (G2059637) >> Installation

Roof Opening Panel Blind (G2059637): Installation

WARNING: This page is about a different car, the 2019 Land Rover Range Rover Velar. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the roof opening panel blind beam.
  2. WARNING: This step requires the aid of another technician.
    • Remove the suitable locking pin from the roof opening panel blind.
    • Install the roof opening panel blind.
    • Tighten the 6 screws.

      Torque  : 3 Nm 

    • Connect the roof opening panel blind electrical connector.
  3. Pull the opening panel blind beam forward to lock the sliding shoes.
  4. Install the 9 wiring harness clips.
  5. Install the headliner.

    Refer to: HEADLINER

  6. Connect the startup battery.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

  7. Roof opening panel motor synchronization procedure.

    Refer to: MOTOR SYNCHRONIZATION 

scientia non olet · About LEMON Manuals