Antilock Brake System (Abs) (Continental) - DTCS C0044-28 To C10D0-92

• DTC Troubleshooting
  • C0044-28-Brake Pressure Sensor 1 - Signal Bias Level Out Of Range / Zero Adjustment Failure
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C0044-49-Brake Pressure 1 - Internal Electronic Failure
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C0044-62-Brake Pressure Sensor 1 - Signal Compare Failure
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C0044-64-Brake Pressure Sensor 1 - Signal Plausibility Failure
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C0051-22-Steering Wheel Position Sensor - Signal Amplitude > Maximum
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C0051-28-Steering Wheel Position Sensor - Signal Bias Level Out Of Range / Zero Adjustment Failure
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C0051-49-Steering Wheel Position Sensor - Internal Electronic Failure
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C0051-54-Steering Wheel Position Sensor - Missing Calibration
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C0051-62-Steering Wheel Position Sensor - Signal Compare Failure
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C006A-28-Multi-Axis Acceleration Sensor - Signal Bias Level Out Of Range / Zero Adjustment Failure
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C006A-49-Multi-Axis Acceleration Sensor - Internal Electronic Failure
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C006A-54-Multi-Axis Acceleration Sensor - Missing Calibration
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C006A-62-Multi-Axis Acceleration Sensor - Signal Compare Failure
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C006A-78 Multi-Axis Acceleration Sensor - Alignment Or Adjustment Incorrect
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C0078-86-Tire Diameter - Signal Invalid
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C1046-92-Left Front Wheel Pressure Phase Monitoring - Performance Or Incorrect Operation
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C1047-92-Right Front Wheel Pressure Phase Monitoring - Performance Or Incorrect Operation
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C1048-92-Left Rear Wheel Pressure Phase Monitoring - Performance Or Incorrect Operation
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C1049-92-Right Rear Wheel Pressure Phase Monitoring - Performance Or Incorrect Operation
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C1082-01-Vacuum Pressure Sensor - General Electrical Failure
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C1082-02-Vacuum Pressure Sensor - General Signal Failure
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C1082-2F-Vacuum Pressure Sensor - Signal Erratic
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C10CD-01-Electronic Park Brake Switch - General Electrical Failure
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C10CD-2A-Electronic Park Brake Switch - Stuck
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C10D0-48-Electronic Park Brake Module - Supervision Software Failure
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C10D0-4B-Electronic Park Brake Module - Over Temperature
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C10D0-52-Electronic Park Brake Module - Not Activated
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C10D0-53-Electronic Park Brake Module - Deactivated
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C10D0-92-Electronic Park Brake Module - Performance Or Incorrect Operation
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test