LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2021 >> Renegade Limited >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> 1.3L Engine (Service Information) >> Lubrication >> Sensor, Oil Temperature >> Removal And Installation

Removal And Installation

REMOVAL 

  1. Disconnect and isolate the negative battery cable.
  2. Remove the air cleaner body. Refer to BODY, AIR CLEANER, REMOVAL AND INSTALLATION  .
    GC0200092Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the oil temperature sensor wire harness connector (1).
    GC0200067Courtesy of CHRYSLER GROUP, LLC
  4. Remove the oil temperature sensor (1).
  5. Make sure that the gasket material does not remain trapped in position on the VVAA module.
  6. Check the sensor seat and threads are clean and free of metal scraps.
  7. Remove and discard the gasket (2).

INSTALLATION 

NOTE:

Handle the oil temperature sensor with care, and do not touch it with your fingers.

  1. Apply three drops of clean engine oil on the threads and the gasket.
  2. Using a NEW  gasket and a 25 mm long socket, install the oil temperature sensor and tighten to the proper torque specification. Refer to TORQUE SPECIFICATIONS  .
  3. Connect the oil temperature sensor wire harness connector.
  4. Install the air cleaner body. Refer to BODY, AIR CLEANER, REMOVAL AND INSTALLATION  .
  5. Install the engine cover. Refer to COVER, ENGINE, REMOVAL AND INSTALLATION  .
  6. Connect the negative battery cable.
scientia non olet · About LEMON Manuals