LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1333 (1.3L Cooling System) >> Engine >> Fan, Cooling >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the cooling fan and engage the retaining clips.
  2. Install and securely tighten the fan to the radiator bolts.
  3. Install the lower radiator support brackets and securely tighten the bolts.
  4. Engage the engine cooling system supply pipe to the retainers on the fan shroud.
  5. Connect the cooling fan wire harness connector.
  6. Install the lower duct and securely tighten the bolts.
  7. Engage the automatic transmission oil pipes retaining clip.
  8. Install the front bumper reinforcement. Refer to REINFORCEMENT, BUMPER, FRONT, INSTALLATION .
  9. Install the front fascia. Refer to FASCIA, FRONT, INSTALLATION .
  10. Install the belly pan. Refer to BELLY PAN, INSTALLATION .
  11. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
scientia non olet · About LEMON Manuals