Sunshade, Sunroof, Power: Adjustments
WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If the sunshade cannot be opened using the switch (2a), do not persist in using the switch, in order not to damage the sunshade motor.
- If possible, using the sunshade switch (2a), open the sunshade to the full open end of travel.
- Remove the sunshade motor. Refer to MOTOR, SUNROOF SHADE, DUAL PANE, REMOVAL
.NOTE:
Use care when sliding the sunshade rearward to avoid jamming due to misalignment, as much as possible.
- With the use of two operators in position, one on each of the two sides of the sunshade, carefully slide the sunshade to the rear end of travel.
- Check that the sunshade is located at the full mechanical end of travel on both the sliding guides.
- If necessary, using a measuring tape or equivalent, check the points of symmetry of the sunshade in relation to the sunroof frame.
- Install the sunshade motor. Refer to MOTOR, SUNROOF SHADE, DUAL PANE, INSTALLATION .