LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1287 (Frame And Bumpers) >> Bumpers >> Fascia, Front >> Disassembly And Assembly >> Assembly

Disassembly And Assembly: Assembly

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the parking sensors if necessary.
  2. Install the air vent if necessary, proceeding as follows:
  3. Install the air vent and seat the retaining clips.
  4. If necessary, install the logo as follows:
  5. Place the logo into position, seat the clip and install the screws.
  6. Reassemble the bottom grille on the front fascia, seat the retainers and install the screws.
  7. Position the top grille front casing onto the fascia and secure the retaining clips.
  8. Position the top grille front trim onto the fascia and secure the retaining clips.
  9. Position the tow hook cap back and seat the retainers fully.
  10. Install the grille reinforcement bracket.
  11. Install the grille. Refer to GRILLE, INSTALLATION .
  12. Install the fascia closeout covers.
  13. Install the turn signal lamp. Refer to LAMP, PARK AND TURN SIGNAL, INSTALLATION .
  14. Install the fog lamps and trim. Refer to FRONT FOG LAMP, INSTALLATION .
  15. Install the front fascia. Refer to FASCIA, FRONT, INSTALLATION  .
scientia non olet · About LEMON Manuals