LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1318 (Lamps/Lighting - Exterior (Service Information)) >> Lamp, Park And Turn Signal >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the turn signal lamp assembly to the vehicle, then install and securely tighten the fasteners for the turn signal lamp assembly.
  2. Connect the wire harness connector to the turn signal lamp assembly.
  3. Install the front wheel splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, INSTALLATION .
  4. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
scientia non olet · About LEMON Manuals