Sunroof, Single Pane: Installation
NOTE:
After installation the sunroof motor will need to be re initialized.
NOTE:
Refer to the for exploded view and call outs. Refer to SUNROOF, SINGLE PANE, DESCRIPTION .
- Verify that glass panel (1) is fully closed.
- With the help of an assistant, through the open liftgate area, place sunroof assembly in vehicle.
- Locate the alignment holes along the sides of the module assembly and position the holes so that they line up with the holes located in the roof top support brackets.
- Raise sunroof module assembly and guide it carefully into position.
- While supporting the sunroof assembly Install the attaching fasteners to 9 N.m. (80 in. lb.)
- Connect the electrical connector.
- Connect the drain tubes to the sunroof, Refer to TUBE, SUNROOF DRAIN, INSTALLATION .
- Connect the battery negative cable.
- Tighten glass panel fasteners, Refer to GLASS, SUNROOF, INSTALLATION .
- Install mechanism covers, Refer to COVER, SUNROOF MECHANISM, INSTALLATION .
- Test sunroof operation, adjust if necessary. Refer to GLASS, SUNROOF, REAR, ADJUSTMENTS .
- Install the headliner. Refer to HEADLINER, INSTALLATION .
- Initialize sunroof motor, Refer to MOTOR, SUNROOF, STANDARD PROCEDURE .