LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2018 >> Grand Cherokee Laredo, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (3.0L Turbo Diesel (Service Information)) >> Engine Block >> Bearing(S), Connecting Rod >> Removal

Bearing(S), Connecting Rod: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect and isolate negative battery cable.
  2. Remove the engine from vehicle. Refer to REMOVAL .
  3. Remove the oil pump pickup tube. Refer to PICK-UP, OIL PUMP, REMOVAL .
    GC0146605Courtesy of CHRYSLER GROUP, LLC
  4. Remove the bolts (1) and the windage tray (2).
    GC0146733Courtesy of CHRYSLER GROUP, LLC
  5. Remove the connecting rod bearing caps one at a time and discard bolts (2).
  6. Carefully remove the upper half and lower bearing half (3) from the connecting rod.
scientia non olet · About LEMON Manuals