Shock Absorber, Suspension: Disassembly
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Do not use any type of pliers on the chrome machined surface of shock/strut rod to assist in the disassembly/assembly of shocks or struts. Use only tools designed to hold the shock/strut rod stationary when servicing shock or strut components.
NOTE:
View is typical
NOTE:
The shock assembly must be removed from the vehicle for it to be disassembled and assembled. Refer to SHOCK ABSORBER, SUSPENSION, REMOVAL .
- Remove the retaining nut (1) using the Matco USS39 Universal Strut/shock kit or equivalent, select the 5.2MM Double D and the 17MM socket.
- Remove the upper shock mount (2).
- Remove the dust shield (3) from the shock body (4).
- Perform the inspection procedure below:
- Inspect the shock absorber (damper) (4) for shaft binding over the full stroke of the shaft.
- Inspect the dust shield (3) for cracks and tears.
- Check the upper mounting bracket (2) for cracks and distortion
- For reassembly, Refer to SHOCK ABSORBER, SUSPENSION, ASSEMBLY .