LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (2.4L Engine (Service Information)) >> Engine Mounting >> Insulator, Engine Mount, Right >> Installation

Insulator, Engine Mount, Right: Installation

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
GC0160072Courtesy of CHRYSLER GROUP, LLC
  1. Position the mount (3) between the engine and the frame rail (5). Make sure the mount is flush to the frame rail.
  2. Tighten the right mount to strut tower bolt (4) finger tight.
  3. Install engine mount to frame retaining bolts (2) finger tight.
  4. Install the right mount to timing cover bolts (1) finger tight.
    GC0156437Courtesy of CHRYSLER GROUP, LLC
  5. Tighten the right mount to strut tower bolt to the proper specification. Refer to TORQUE SPECIFICATIONS  .
    GC0160072Courtesy of CHRYSLER GROUP, LLC
  6. Tighten the right mount to frame rail bolts (2) to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  7. Tighten the engine mount to timing cover bolts (1) to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  8. Remove the jack stand.
  9. Install the coolant reservoir bottle and tighten the bolt to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  10. Install the air cleaner body. Refer to INSTALLATION  .
  11. Install the engine cover.
  12. Install the belly pan. Refer to BELLY PAN, INSTALLATION .
scientia non olet · About LEMON Manuals