LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2006 >> Commander Base, 3.7 K, RWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Body - Interior & Exterior >> Stationary Glass >> Windshield >> Removal

Stationary Glass: Windshield: Removal

Fig 1: Adhesive Separation
G04286450Courtesy of DAIMLERCHRYSLER CORP.
  1. Before proceeding with the following repair procedure, review all warnings and cautions (Refer to BODY/STATIONARY GLASS - WARNING) .
  2. Remove the rear view mirror (Refer to BODY/INTERIOR/REAR VIEW MIRROR - REMOVAL) .
  3. Remove the rain sensor module from the windshield (Refer to ELECTRICAL/WIPERS/WASHERS/RAIN SENSOR MODULE - REMOVAL) .
  4. Remove the cowl grille (Refer to BODY/EXTERIOR/COWL GRILLE - REMOVAL.) 
    CAUTION: Be careful not to damage painted surfaces when removing moldings or cutting urethane around the windshield.
  5. Remove molding from the top of the windshield.
  6. Using an assistant and a wire-type windshield cut-out tool (1, 3 and 4), cut and separate the urethane adhesive (2) securing the windshield to the windshield fence.
  7. Carefully remove the windshield from the vehicle.
scientia non olet · About LEMON Manuals