3.0L Diesel
WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - COOLANT HOSE |
| 2 - WATER PUMP |
| 3 - WATER PUMP BOLTS |
| 4 - IDLER PULLEY |
| 5 - IDLER PULLEY CAP |
| 6 - COOLANT HOSE |
WARNING:
RISK OF INJURY TO SKIN AND EYES FROM SCALDING WITH HOT COOLANT. RISK OF POISONING FROM SWALLOWING COOLANT. DO NOT OPEN COOLING SYSTEM UNLESS COOLANT TEMPERATURE IS BELOW 90°C (194°F). OPEN CAP SLOWLY TO RELEASE PRESSURE. STORE COOLANT IN SUITABLE AND APPROPRIATELY MARKED CONTAINER. WEAR PROTECTIVE GLOVES, CLOTHES AND EYE WEAR.
- Disconnect negative battery cable.
- Remove engine cover (Refer to ENGINE - REMOVAL)(Refer to ENGINE - REMOVAL)(Refer to ENGINE - REMOVAL) .
- Drain engine coolant (Refer to COOLING/ENGINE/COOLANT - STANDARD PROCEDURE) .
- Remove accessory drive belt (Refer to COOLING/ACCESSORY DRIVE/DRIVE BELTS - REMOVAL) .
- Disconnect coolant hoses at water pump.
- Remove idler pulley.
- Remove water pump and clean sealing surfaces. See Fig 1.