LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 504 (Body - Interior & Exterior) >> Interior >> Headliner >> Removal

Section 504 (Body - Interior & Exterior): Interior: Headliner: Removal

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the a-pillar trim. (Refer to BODY/INTERIOR/A-PILLAR TRIM AND GRAB HANDLE - REMOVAL) .
  2. Remove the visors. (Refer to BODY/INTERIOR/SUN VISOR - REMOVAL) .
  3. Remove the sun visor support. (Refer to BODY/INTERIOR/SUN VISOR SUPPORT - REMOVAL) .
  4. Remove the overhead console. (Refer to ELECTRICAL/OVERHEAD CONSOLE - REMOVAL) .
  5. Cut rear washer hose at the mark about halfway up the a-pillar.
  6. Remove the upper b-pillar trim. (Refer to BODY/INTERIOR/B-PILLAR UPPER TRIM - REMOVAL) .
  7. Remove the assist handles. (Refer to BODY/INTERIOR/ASSIST HANDLE - REMOVAL) .
  8. Remove the quarter trim. (Refer to BODY/INTERIOR/QUARTER TRIM PANEL - REMOVAL) .
  9. Disconnect the electrical connector along the left d-pillar and remove the ground wire.
  10. Remove the dome light in the rear.
  11. Remove the sunroof opening trim lace, if equipped. (Refer to BODY/SUNROOF/OPENING TRIM LACE - REMOVAL) .
  12. Remove the rear washer nozzle.
  13. Remove the headliner.