Quarter Trim Panel: Removal

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.

Using a trim stick C-4755 or equivalent, remove the rear header trim.
Using a trim stick C-4755 or equivalent, remove the rear sill plate.
Remove the hook pin type connector.
Fold down the rear seat.
Remove the seat belt anchor and pivot. (Refer to ELECTRICAL/RESTRAINTS/SEAT BELT & RETRACTOR - REMOVAL) .
Remove the belt access panel. See Fig 1.
Remove the storage cover.
Disconnect the 12v power supply electrical connector, if equipped.

Fig 1: Quarter Trim Panel

Courtesy of DAIMLERCHRYSLER CORP.

1 - C-PILLAR

2 - D-PILLAR

3 - BELT ACCESS PANEL

4 - QUARTER TRIM PANEL