LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Engine Controls - Tests W/Codes - 3.0L) >> No-Start Tests >> Test NS-7E - Inspecting Idle Air Control Motor Operation

Test NS-7E - Inspecting Idle Air Control Motor Operation

WARNING: This page is about a different car, the 1994 Plymouth Sundance, 1994 Plymouth Acclaim, 1994 Dodge Spirit, 1994 Dodge Shadow, and 1994 Chrysler LeBaron. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For circuit and connector terminal identification, see CONNECTOR IDENTIFICATION DIRECTORY  . For wiring diagrams, see WIRING DIAGRAMS  .
  1. Turn ignition off. Disconnect Powertrain Control Module (PCM) connector. Inspect all terminals. Repair as required. Perform TEST VER-1. If PCM terminals are okay, go to next step.
  2. Using an external ohmmeter, check resistance of Yellow/Black wire between IAC motor connector and PCM connector terminal No. 60. If resistance is less than 5 ohms, replace PCM. Perform TEST VER-1  . If resistance is more than 5 ohms, repair open in Yellow/Black wire. Perform TEST VER-1.
scientia non olet · About LEMON Manuals