Test 7B - Repairing Security Indicator Light Circuit

WARNING: This page is about a different car, the 1995 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For connector terminal identification, see Figure .

NOTE: Perform TEST 7A before proceeding.

Turn ignition off and disconnect VTA module. See Figure in TEST 1A and see VEHICLE THEFT ALARM MODULE under REMOVAL & INSTALLATION. Inspect connector, clean and repair as needed. If security indicator light comes on, repair short to ground in security indicator light control (Black/Orange wire). Perform TEST VER-1A . If security indicator light does not come on, replace VTA module. Refer to VEHICLE THEFT ALARM MODULE under REMOVAL & INSTALLATION. Perform TEST VER-1A .