LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 195 (Anti-Theft System) >> Testing >> Test 6B - Repairing Horn Circuit

Test 6B - Repairing Horn Circuit

WARNING: This page is about a different car, the 1995 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For connector terminal identification, see Figure .
NOTE: Perform TEST 6A  before proceeding.
  1. Remove and inspect fuse No. 13. If fuse is okay, go to next step. If fuse is open, using DRB in ohmmeter mode, check resistance at VTA module connector terminal No. 9 (Black/Tan wire). If resistance is more than 5 ohms, replace fuse and Perform TEST VER-1A  . If resistance is less than 5 ohms, repair short to ground in Black/Tan wire circuit, replace fuse and Perform TEST VER-1A  .
  2. With DRB in voltmeter mode, check voltage on ignition feed circuit side of fuse receptacle (Red/Yellow wire on left side of receptacle). If voltage is more than 10 volts, repair open fused battery feed circuit (Black/Red wire). Perform TEST VER-1A  . If voltage is less than 10 volts, repair open battery feed circuit (Red/Yellow wire) between the fuse block and the power distribution center. Perform TEST VER-1A  .
scientia non olet · About LEMON Manuals