Test 14A - Repairing VTA Disarm Sense Left Door Circuit
WARNING: This page is about a different car, the 1995 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For connector terminal identification, see Figure
.
NOTE:
Perform TEST 1A
before proceeding.
- Using DRB, read DOOR KEY CYLINDER SWITCH status. If DRB displays CIRCUIT CLOSED, go to TEST 15B . If DRB does not display CIRCUIT CLOSED, disconnect left front door switch connector. Inspect connector, clean and repair as needed. Connect jumper wire across both terminals of connector and go to next step.
- Using DRB, read door key cylinder switch status. If DRB displays CIRCUIT CLOSED, replace left front door key cylinder switch. Perform TEST VER-1A . If DRB does not display CIRCUIT CLOSED, go to next step.
- Connect jumper wire between disarm sense circuit at left front door switch connector terminal No. 2 (Violet/Yellow wire) and ground. Using DRB, read door key cylinder switch status. If DRB displays CIRCUIT CLOSED, repair open in switch ground circuit (Black wire). If DRB does not display CIRCUIT CLOSED, go to next step.
- Without disconnecting VTA module connector, using a jumper wire backprobe VTA module connector terminal No. 4 (Violet/Yellow wire) to ground. Using DRB, read door key cylinder switch status. If DRB displays CIRCUIT CLOSED, repair VTA module open disarm sense circuit (Violet/Yellow wire). Perform TEST VER-1A . If the DRB does not display CIRCUIT CLOSED, replace the VTA module. Refer to VEHICLE THEFT ALARM MODULE under REMOVAL & INSTALLATION in this article. Perform TEST VER-1A .