LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 195 (Anti-Theft System) >> Testing >> Test 10B - Repairing Hood Ajar Circuit

Test 10B - Repairing Hood Ajar Circuit

WARNING: This page is about a different car, the 1995 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For connector terminal identification, see Figure .
NOTE: Perform TEST 10A  before proceeding.
  1. Disconnect hood ajar switch. Connect jumper wire between hood ajar switch connector (Brown/Tan wire) and ground. Using DRB, read HOOD AJAR switch status. If DRB displays CLOSED, replace hood ajar switch. Perform TEST VER-1A  . If DRB does not display CLOSED, locate the VTA module connector and go to the next step. Refer to VEHICLE THEFT ALARM MODULE  under REMOVAL & INSTALLATION.
  2. Without disconnecting VTA module connector, using a jumper wire backprobe VTA module connector terminal No. 12 (Brown/Tan wire) to ground. Using DRB, read HOOD AJAR switch status. If DRB displays CLOSED, repair open hood ajar sense circuit (Brown/Tan wire). Perform TEST VER-1A  . If DRB does not display CLOSED, replace VTA module. Perform TEST VER-1A  .
scientia non olet · About LEMON Manuals