Pinpoint Test G: Luggage Compartment Lid Does Not Close
- G1: SWITCH TEST NOTE: Before beginning this pinpoint test it may be useful to complete Pinpoint Test S, if not already completed
- Using the Jaguar Land Rover Approved Diagnostic Equipment, check all associated DTCs with central junction box & luggage compartment lid control module
- DO NOT REPAIR DTCS - NO PARTS TO BE CHANGED WITHOUT FIRST ISOLATING THE FAILURE MODE
Are there any DTCs present in the luggage compartment lid control module?
Yes: GO to PINPOINT TEST A: DTC TEST
No: GO to G2.
- G2: SWITCH TEST
- Press the luggage compartment lid close switch
Does the luggage compartment lid begin to power close?
Yes: Follow steps 3 and 4 then Go to 5
Ensure the luggage compartment lid is returned to the fully open position
No: GO to G3.
- Press the luggage compartment lid close switch
- G3: SWITCH TEST
- Press the smart key close switch
Does the luggage compartment lid begin to power close?
Yes: Follow steps 2 and 4 if not already performed, then Go to 5
Ensure the luggage compartment lid is returned to the fully open position
No: GO to G4.
- Press the smart key close switch
- G4: SWITCH TEST
- Press the luggage compartment lid interior close switch
Does the luggage compartment lid begin to power close?
Yes: Follow steps 2 and 3 if not already performed, then Go to 5
No: GO to G6.
- Press the luggage compartment lid interior close switch
- G5: SWITCH TEST
- After testing all three release switch operations
Did the luggage compartment lid begin powered operation from all three switch inputs?
Yes: GO to PINPOINT TEST K .
No: Refer to the electrical circuit diagrams and check the luggage compartment lid release switch for open circuit, high resistance, repair the circuit as necessary. Refer to the relevant article of the repair information and install a new part as necessary
Check switch concerned for any obvious damage or corrosion
On the warranty claim please quote feedback ID "FID 3.1"
- After testing all three release switch operations
- G6: CAN BUS CHECK
- Using the Jaguar Land Rover Approved Diagnostic Equipment, check if the luggage compartment lid control module is live on the medium speed CAN bus
Is the luggage compartment lid control module live on the CAN bus?
Yes: GO to PINPOINT TEST H .
No: Using the Jaguar Land Rover Approved Diagnostic Equipment, clear the DTCs and retest. If the fault persists, install a new luggage compartment lid control module as necessary
On the warranty claim please quote feedback ID "FID 3.2"
- Using the Jaguar Land Rover Approved Diagnostic Equipment, check if the luggage compartment lid control module is live on the medium speed CAN bus