Pinpoint Test H: Anti-Trap Sensor Test
- H1: ANTI-TRAP SENSOR TEST NOTE:
- Before installing a new sensor, refer to the electrical circuit diagrams and check the anti-trap sensor circuit for short circuit to power, open circuit, high resistance. Repair circuit if required. If the fault persists, install a new sensor
- Before beginning this pinpoint test it may be useful to complete Pinpoint Test S, if not already completed
- Inspect the anti-trap sensors on either side of the luggage compartment lid. Pay particular attention to the radius at the top of the luggage compartment lid
Is there evidence of abrasion/wear and tear?
Yes: Using the Jaguar Land Rover Approved Diagnostic Equipment, check datalogger signal - Anti Pinch Seal Switch Status D903 when the luggage compartment lid is closed. If the signal indicates that the sensor is activated, refer to the relevant article of the repair information and install a new sensor as necessary. Also check the drain trough finishers in the affected area for correct fitment. Ensure clearance is achieved after refitting the anti-trap sensor
On the warranty claim please quote feedback ID "FID 3.3"
No: GO to H2.
- H2: ANTI-TRAP SENSOR TEST
- Inspect the end of the anti-trap sensors on either side of the luggage compartment lid, where the wire exits the sensor
Is there evidence of wear and tear or insulation break through?
Yes: Refer to the relevant article of the repair information and install a new anti-trap sensor as necessary
On the warranty claim please quote feedback ID "FID 3.4"
No: GO to H3.
- Inspect the end of the anti-trap sensors on either side of the luggage compartment lid, where the wire exits the sensor
- H3: ANTI-TRAP SENSOR TEST
- Inspect the fitment of the anti-trap sensor to the luggage compartment lid
Are all clips fully engaged and the sensor securely located?
Yes: GO to PINPOINT TEST I . LUGGAGE COMPARTMENT LID POSITIONAL DATA TEST
No: If possible re-seat the anti-trap sensor correctly and check for correct operation. If not possible refer to the relevant article of the repair information and install a new anti-trap sensor as necessary
On the warranty claim please quote feedback ID "FID 3.5"
- Inspect the fitment of the anti-trap sensor to the luggage compartment lid