LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Seat Heating System And Seat Cooling System) >> Repair Instructions >> Rear Seat Heater Control Module Replacement

Rear Seat Heater Control Module Replacement

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View of Rear Seat Heater Control Module
GM1571694Courtesy of GENERAL MOTORS CORP.
Rear Seat Heater Control Module Replacement

Callout Component Name
NOTE: Refer to Fastener Notice .
Refer to Fastener Tightening Specifications .

Preliminary Procedures

  1. Remove the rear seat back cushion. Refer to Seat Back Replacement - Rear .
  2. Remove the rear seat armrest. Refer to Rear Seat Armrest Replacement .
  3. Remove the rear seat back cushion cover and pad. Refer to Rear Seat Back Cushion Cover and Pad Replacement .
Refer to Control Module References for replacement and setup information.
1 Rear Seat Heater Control Module Screws (Qty: 2)
NOTE: Refer to FASTENER NOTICE .

Tighten:  2 N.m (18 lb in)

2 Rear Seat Heater Control Module
Procedure 
  1. Disconnect the electrical connector.
  2. Refer to Control Module References for replacement and setup information.