Seat Back Replacement - Rear

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Seat Back Replacement - Rear

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the rear seat cushion. Refer to Rear Seat Cushion Replacement .
1	Bolt, Rear Seat Back Cushion NOTE: Refer to Fastener Notice . Tighten: 2 N.m (18 lb in)
2	Cushion, Rear Seat Back Tip: Insert a flat-bladed tool between the top of the rear seat back and the rear shelf. Push the flat-bladed tool down to release the four retainers in order to remove the rear seat back. Disconnect the electrical connectors, if equipped.