LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Rear Suspension System) >> Repair Instructions >> Wheel Stud Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Installing Wheel Stud
GM161272Courtesy of GENERAL MOTORS CORP.
  1. Install the new wheel stud.
  2. Using washers and a wheel nut, pull the wheel stud in position.
  3. Install the brake rotor. Refer to Rear Brake Rotor Replacement (J55) or Rear Brake Rotor Replacement (JL9) .
    NOTE: Refer to Fastener Notice .
  4. Install the brake caliper and bolts. Refer to Rear Brake Caliper Replacement (J55) or Rear Brake Caliper Replacement (JL9) .
  5. Install the wheel and the tire. Refer to Tire and Wheel Removal and Installation .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals