Diagnosis Procedure

1. Select "INTELLIGENT KEY" of "BCM" using CONSULT.
2. Select "ANTI KEY LOCK IN FUNCTI" in "WORK SUPPORT" mode.
3. Check "ANTI KEY LOCK IN FUNCTI" setting in "WORK SUPPORT".

   Refer to CONSULT Function (BCM - INTELLIGENT KEY) .

Is the inspection result normal?

YES

GO TO 2.

NO

Set "On" in "ANTI KEY LOCK IN FUNCTI".

Check inside key antenna.

• Instrument center: Refer to DTC Logic .
• Console: Refer to DTC Logic .
• Trunk room: Refer to DTC Logic .

Is the inspection result normal?

YES

GO TO 3.

NO

Repair or replace the malfunctioning parts.

Check door switch.

Refer to Component Function Check .

Is the inspection result normal?

YES

GO TO 4.

NO

Repair or replace the malfunctioning parts.

Check trunk lid open signal circuit.

Refer to Component Function Check .

Is the inspection result normal?

YES

GO TO 5.

NO

Repair or replace the malfunctioning parts.

Check unlock sensor.

Refer to Component Function Check .

Is the inspection result normal?

YES

GO TO 6.

NO

Repair or replace the malfunctioning parts.

• Replace BCM. Refer to Removal and Installation .
• Confirm the operation after replacement.

Is the result normal?

YES

INSPECTION END

NO

Check intermittent incident. Refer to Intermittent Incident .