Service After Replacing Li-Ion Battery Parts: Description

WARNING: This page is about a different car, the 2016 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.

The work procedure for replacing Li-ion battery parts depends on parts or part combinations. When replacing Li-ion battery parts, refer to the table below:

: Replacement

Replacement parts				Remarks	Remarks
LBC	One module	All modules (12)	Battery pack (Include LBC)	Remarks	Remarks
*	-	-	-	LBC data must be moved Configuration must be performed	WORK PROCEDURE
*	*	-	-	LBC data must be moved Configuration must be performed	WORK PROCEDURE
-	-	*	-	LBC data must be erased	WORK PROCEDURE
*	-	*	-	Unnecessary to move/erase LBC data Configuration must be performed	WORK PROCEDURE
-	*	-	-	Unnecessary to move/erase LBC data	WORK PROCEDURE
-	-	-	*	Unnecessary to move/erase LBC data Configuration must be performed	WORK PROCEDURE

NOTE:

There is no change in the work procedure when Li-ion battery parts (e.g. battery junction box and service plug) other than those listed in the above table are replaced simultaneously.
To replace Li-ion battery controller (LBC), battery information stored in LBC must be saved in a new LBC.